Owner`s manual

DS72 Host Module

Configuration Menu

The configuration menu allows the admin user to choose a module to access and edit its configuration.

The following pages define each line of the configuration menu.

Enter the number that corresponds with the Host Module followed by a <cr> and the Host Module

responds without the option description:

Configuration Status

Used to view the status of the installed modules, network setup, login setup, and associated

information by issuing a series of carriage returns. The following are the factory default settings:

DS72 Data Switch Series - Telnet Host Module

Revision F.3.21.4 Kernel K.1.01H

Core C.1.00N Hardware H.2.01

Module 2

Status..........................1 Current status of DS72 module

Serial Port Configuration.......2 Change port config, 9600, 8, 1, none

Port Device Name................3 Change the name of the module port

Attention Character.............4 (;;;;;) get Main Menu

Disconnect Timeguard............5 Delay to see if more data after ‘;’ char

Connection Override.............6 User override another for priority

Connect Port ID Echo............7 Enable echo module & port#, device name

SNMP Configuration..............9 Trap Address, Read/Write, Enable/Disable

Network Port Configuration......10 Ethernet configuration menu

Unit ID.........................11 Name of the module

Upgrade Firmware................12 FTP-Firmware upgrade w/user password

Active Restore..................13 Allow units to internally reset for

freezes, login idle timeouts,

RPC Management..................14 Set thresholds temp/v/c

Exit............................X,CR

Enter Request :1

Configuration

DS72 ................1 Host Module

DS74 Module# 3 ................2 I/O Serial port

DS-RPC ................3 Assign users, outlet name, E/D

confirmation/status menu, unit id,

alarm set.

Exit............................X,CR