Specifications

5
Interface Processor Installation and Configuration Guide
78-4211-02
Confirming Interface Processor Compatibility
Determining Board Part Number and Revision
You can determine the part number and board revision of your interface processor in one of two ways:
• Inspect the physical board
• Use the show diagbus command online
Figure 2 provides a flowchart to determine if your new interface processor is compatible with your
existing interface processor, using board part numbers and revision levels.
CX-AIP-E3 - Does not require an upgrade
CX-EIP2 73-1129-02 N0 or later
CX-EIP4 73-1132-02 N0 or later
CX-EIP6 73-0906-02 N0 or later
CX-FIP-MM 73-0892-03 M0 or late
CX-FIP-MS 73-1093-03 M0 or later
CX-FIP-SM 73-1090-03 M0 or later
CX-FIP-SS 73-1087-03 M0 or later
CX-FSIP4 73-1187-05 A0 or later
CX-FSIP8 73-1126-05 A0 or later
All other interface processors - -
1. Any interface processors not specifically listed in the table are compatible with Cisco 7500 series or RSP7000.
2. A board part number is compatible with Cisco 7500 series or Cisco 7000 series with an RSP7000 processor option if it is
equal to or greater than those listed in this column.
3. The suffix of the part number reflects the fab revision. (See the “Determining Board Part Number and Revision” section on
page 5)
4. It may not be necessary to check the board revision level, because the part number suffix itself may determine compatibility.
5. A board revision should be checked only if the part number suffix is equal to those listed in the table. In this case, the board
revision must be greater than or equal to those listed in the table.
Table 1 Interface Processor Compatibility Guidelines
1
(continued)
Product Number Board Part Number
2
Board Revision
345