Specifications

4
Interface Processor Installation and Configuration Guide
78-4211-02
Confirming Interface Processor Compatibility
– Documentation Feedback, page 33
– Cisco.com, page 33
– Technical Assistance Center, page 34
Confirming Interface Processor Compatibility
This section describes how to determine if your interface processor is compatible with your existing
equipment.
This section includes the following information:
Process Flowchart, page 4
Determining Board Part Number and Revision, page 5
Process Flowchart
Before installing a new interface processor, determine if it is compatible with your existing legacy
interface processors, using the following flowchart (Figure 1) in conjunction with Table 1. To determine
your board number and revision, refer to the “Determining Board Part Number and Revision” section on
page 5.
Figure 1 Interface Processor Compatibility Flowchart
Do you have an
EIP, FIP, FSIP, or AIP
that you want to install
in your router?
Did you receive
your EIP, FIP, or FSIP
before January 1995? Did
you receive your AIP
before March
1995?
Does
your EIP,
FIP, FSIP, or AIP
have part number and
board revision level earlier
than listed in the
Compatibility
Guidelines
Table?
Your interface processors
are compatible
No No No
Yes Yes Yes
P1141
For pricing or ordering
information, contact your
Cisco representative or call
408 526-7355 and reference
the Investment Protection
Program (IPP).
Table 1 Interface Processor Compatibility Guidelines
1
Product Number Board Part Number
2
Board Revision
345
CX-AIP-SS 73-1188-02 D0 or later
CX-AIP-SM 73-1188-02 D0 or later
CX-AIP-TM 73-1188-02 D0 or later
CX-AIP-DS3 - Does not require an upgrade