Specifications

27
Interface Processor Installation and Configuration Guide
78-4211-02
Interface Processor Installation Procedures
Step 3 Interface processors and interface processor fillers are secured with two captive installation screws.
(See Figure 13a.) Use a flat-blade screwdriver to loosen the captive installation screws and remove the
interface processor filler (or the existing interface processor) from the slot. If you remove an interface
processor, immediately place it in an antistatic bag to prevent damage from electrostatic discharge.
Figure 13 Location of Ejector Levers and Captive Installation Screws
Step 4 Hold the interface processor handle with one hand, and place your other hand under the carrier to
support the interface processor (see Figure 12); guide the carrier into the slot. Avoid touching the card
or any connector pins.
Caution To prevent ESD damage, handle interface processors by the handles and carrier edges only.
Step 5 Place the back of the interface processor in the slot and align the notch on the bottom of the carrier with
the groove in the slot. (See Figure 13a.)
Interface processor
card slot
Interface processor card
carrier guide (black)
Ejector
lever
Captive
installation
screw
H9846
a
b
c