Specifications

Interface Processor Installation and Configuration Guide

78-4211-02

Interface Processor Description

LEDS

The interface processor has several status LEDs on its faceplate, next to each port, which indicate

conditions on that port. (See Figure 6.)

After system initialization, the enabled LED goes on to indicate that the FSIP has been enabled for

operation.

The following conditions must be met before the interface processor is enabled:

• The interface processor microcode is valid and has been downloaded successfully.

• The interface processor is correctly connected to the backplane and is receiving power.

• The system bus recognizes the interface processor.

If any one of these conditions is not met, or if the initialization fails, the enabled LED does not go on.

Refer to the specific installation and configuration guide for your interface processor at

http://www.cisco.com/univercd/cc/td/doc/product/core/cis7505/interpro/index.htm to more completely

understand the LEDs for your interface processor.

Figure 6 LEDs on a GEIP+ Example—Partial Faceplate View Shown

Slot Locations in the Cisco 7000 and Cisco 7500 Series Routers

Interface processors are installed in the interface processor slots of the Cisco 7000 series and Cisco 7500

series routers. Interface processors are keyed so they cannot be installed in noninterface processor slots,

that is the route switch processor (RSP) slots.

The interface processor slots in the Cisco 7000 series and Cisco 7500 series routers are as follows:

• Cisco 7000—slots 0 through 4 (See Figure 7.)

• Cisco 7010—slots 0 through 2 (See Figure 8.)

• Cisco 7505—slots 0 through 3 (See Figure 9.)

• Cisco 7507—slots 0 and 1, and slots 4 through 6 (See Figure 10.)

• Cisco 7513—slots 0 through 5, and slots 8 through 12 (See Figure 11.)

• Cisco 7576—slots 0 through 5, and slots 8 through 12 (See Figure 11.)

Note The interface processor slots are oriented horizontally in the Cisco 7010 and Cisco 7505, and

vertically in the Cisco 7000, Cisco 7507, Cisco 7513 and Cisco 7576.

38585

RXTX

ENHANCED GIGABIT ETHERNET

LINK

ENABLED