Datasheet

Data Sheet
© 2010 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 3 of 6
Table 2. Product Specifications
Physical Specifications
Power Power supply: Universal AC power supply 100 and 240V
Power adaptor output voltage: +12.0 VDC at 1A maximum
Noise level Less than 34 dBA at 3 feet
Connectors 2 RJ 11
Thermal Operating temperature: 23 to 113°F (5 to 45 °C)
Non-operating temperature: -13 to 158ºF (-25 to 70ºC)
Humidity Operating humidity: 5 to 95% noncondensing
Mean time between failure (MTBF) 100,000 hours
Physical dimensions
(H x W x D) and weight
Dimensions: 1.5 x 5.4 x 6.7 in. (3.8 x 13.7 x 17.0 cm)
Weight: 9.2 oz (260g)
Compliance RoHS- and WEEE-compliant materials
On-off switch To turn device on and off
Software Specifications
Cisco ATA SIP services
●
IP address assignment: Provided by DHCP or statically configured
●
Cisco ATA configuration through Cisco UCM configuration interface
●
VLAN configuration
●
Cisco Discovery Protocol
●
Low-bit-rate codec selection
●
User authentication
●
Configurable tones (dial tone, busy tone, alert tone, reorder tone, and call-waiting tone)
●
Dial plans
●
SIP proxy server redundancy
●
Privacy features
●
Domain Name System (DNS) service (SRV) support
●
User-configurable, call waiting; permanent default setting
●
Comfort noise during silence period when using G.711
●
Advanced audio mode
●
Caller ID format
●
Ring cadence format
●
Silence suppression
●
Hook-flash detection timing configuration
●
Configurable on-hook delay
●
Type of service (ToS) configuration for audio and signaling Ethernet packets
●
Debugging and diagnostic tools
SIP services Cisco ATA supports the methods listed here (for more information, refer to RFC-3261):
●
REGISTER
●
REFER
●
INVITE
●
BYE
●
CANCEL
●
NOTIFY
●
OPTIONS
●
ACK
●
SUBSCRIBE