Specifications

A-4
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Appendix A How to Use Pre-call and Mid-call Services
Procedures for Using Mid-call Services
MeetMe Conference
To use this feature, follow these steps:
Procedure
Step 1 Pick up the handset, press ** then 5 on your telephone keypad. You are prompted to enter a MeetMe
Conference number to reserve a conference.
Step 2 When someone dials the MeetMe Conference number, you receive a confirmation tone and can begin
conferencing with the caller.
Procedures for Using Mid-call Services
The method of initiating and using mid-call services during a call when using SCCP differs according
to mode, which is configured by the Cisco
ATA administrator using the ConnectMode parameter (see
the
“ConnectMode” section on page 5-21). Use the procedures for the mid-services mode that is
configured on your Cisco ATA.
The following three modes are used for invoking mid-call services:
• Bellcore Style, page A-4
• Cisco VG248 Style, page A-5
• Cisco ATA Style, page A-6
Bellcore Style
The following two procedures are unique to the Bellcore (default) style:
• Bellcore Style Call Transfer Procedure, page A-4
• Bellcore Style Conference Call Procedure, page A-5
Bellcore Style Call Transfer Procedure
Step 1 Perform a hook flash to place the current call on hold and obtain a second dial tone.
Step 2 At the dial tone, enter the telephone number or speed dial of the third party and wait for the call to ring.
Step 3 You have the following options:
• To transfer the call, hang up when the call rings or when the third party answers.
• To return to the original call, perform a hook flash before the call rings. If you perform a hook flash
before the third party answers but after the call rings, you also return to the original call.