Specifications

7-6
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Chapter 7 Upgrading the Cisco ATA Signaling Image
Confirming a Successful Signaling Image Upgrade
Upgrade Procedure
To perform the upgrade, follow these steps:
Procedure
Step 1 Run the executable file (see the “Syntax” section on page 7-5) from the Microsoft Windows DOS or
command prompt. You will receive instructions on how to upgrade.
Step 2 On the Cisco ATA, press the function button to invoke the voice configuration menu.
Step 3 Using the telephone keypad, enter the following:
100# ip_address_of_PC * port #
This is the IP address of the PC and the port number at the DOS prompt where you invoked the
sata186us.exe file.
For example, if the IP address is 192.168.1.10, and the port number is 8000 (the default), then enter:
100#192*168*1*10*8000#
When the upgrade is complete, the "Upgrade Successful" prompt will sound.
Note When upgrading many Cisco ATAs manually, you can save the software-upgrade dial-pad sequence in
your telephone's speed-dial, and use this sequence repeatedly.
Confirming a Successful Signaling Image Upgrade
You can verify that you have successfully upgraded the Cisco ATA signaling image by using one of the
following methods:
• Using a Web Browser, page 7-7
• Using the Voice Configuration Menu, page 7-7