Specifications

xii
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Preface
Conventions
Conventions
This document uses the following conventions:
• Alternative keywords are grouped in braces and separated by vertical bars (for example, {x | y | z}).
• Arguments for which you supply values are in italic font.
• Commands and keywords are in boldface font.
• Elements in square brackets ([ ]) are optional.
• Information you must enter is in boldface screen font.
• Optional alternative keywords are grouped in brackets and separated by vertical bars (for example,
[x | y | z]).
• Terminal sessions and information the system displays are in screen font.
Note Means reader take note. Notes contain helpful suggestions or references to material not covered in the
publication.
Chapter 3, “Configuring the Cisco ATA for SCCP” Provides information about how to configure the Cisco ATA
and the different configuration methods you can use.
Chapter 4, “Adding the Cisco ATA to the
Cisco CallManager”
Provides information about adding the Cisco ATA to the
Cisco
CallManager environment.
Chapter 5, “Parameters and Defaults” Provides information on the parameters and defaults that you
can use to configure the Cisco
ATA .
Chapter 6, “Configuring and Debugging Fax Services” Provides instructions for configuring both ports of the
Cisco
ATA to support fax transmission.
Chapter 7, “Upgrading the Cisco ATA Signaling Image.” Provides instructions for remotely upgrading Cisco ATA
software.
Chapter 8, “Troubleshooting” Provides basic testing and troubleshooting procedures for the
Cisco
ATA.
Appendix A, “How to Use Pre-call and Mid-call Services” Provides end-user procedures on how to use pre-call services
and mid-call services that the Cisco
ATA supports.
Appendix B, “Voice Menu Codes” Provides a quick-reference list of the voice configuration
menu options for the Cisco
ATA.
Appendix C, “Cisco ATA Specifications” Provides physical specifications for the Cisco ATA .
Appendix D, “Performing a Cross-Protocol Upgrade” Provides instructions on changing from SCCP to a SIP,
MGCP or H.323 signaling image.
Appendix E, “Recommended Cisco ATA Tone Parameter
Values by Country”
Provides tone parameters for various countries.
Glossary Provides definitions of commonly used terms.
Index Provides reference information.
Table 1 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Administrator’s Guide (SCCP) Organization (continued)
Chapter Description