Installation guide

4-21
Cisco ASA 5500-X Series Hardware Installation Guide
OL-32129-01
Chapter 4 Maintenance and Upgrade Procedures for the ASA 5500-X
Remove and Install the Power Supply
Figure 4-26 Removing the Slot Cover
Step 6
If you are replacing a power supply, follow these steps:
a. Remove the wires from the DC power supply by inserting a small flat-head screwdriver into the
square hole above each wire to relieve the spring pressure, and then gently pull the wire out of the
power supply. (See Figure 4-27.)
Figure 4-27 Removing the Wires from the DC Power Supply
b. Push the locking lever on the power supply to the left and remove the power supply by grasping the
handle and then pulling the power supply out of the chassis while supporting it from beneath with
the other hand. (See Figure 4-28.)
Figure 4-28 Removing the DC Power Supply
Step 7
Install the new power supply by lining it up with the power supply bay and pushing it into place until it
is seated while supporting it from beneath with the other hand. (See Figure 4-29.)
333063
333
225
333224