Installation guide

3-6
Cisco ASA 5500-X Series Hardware Installation Guide
OL-32129-01
Chapter 3 Installing and Connecting the ASA 5500-X
Rack Mount the Chassis
Before You Begin
• Verify the box contents
• Verify the rack type
The slide rails are pre-assembled for square hole racks. Additional steps are required for round hole
racks and threaded hole racks. The following figure shows the slide rail with square hole rack inserts.
• Locate the necessary tools—a Phillips screwdriver and a flat-head screwdriver (for threaded
hole racks).
A Slide Rails (x2) (preconfigured for square hole
racks)
B Phillips flat-head screws for Inner Slide (x2)
C Round Hole Inserts for round hole racks (x4) D Threaded Hole Brackets for threaded hole
racks (x2)
E Threaded Hole Standoffs for threaded hole
racks (x2)
F Phillips pan-head screws for threaded hole
racks (x8)
300885
A
B C D E F
330903