Installation guide

Cisco ASA 5500-X Series Hardware Installation Guide

OL-32129-01

About This Guide

Document Conventions

Multiple Power Cords

Warning

This unit has more than one power cord. To reduce the risk of electric shock when servicing a unit,

disconnect the power cord of the power strip into which the unit is plugged.

Statement 137

Circuit Breaker (15A) Warning

Warning

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that

a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the

phase conductors (all current-carrying conductors).

Statement 13

48 VDC Power System

Warning

The customer 48-volt power system must provide reinforced insulation between the primary AC power

and the 48 VDC output.

Statement 128

Grounded Equipment Warning

Warning

This equipment is intended to be grounded. Ensure that the host is connected to earth ground during

normal use.

Statement 39

Safety Cover Requirement

Warning

The safety cover is an integral part of the product. Do not operate the unit without the safety cover

installed. Operating the unit without the cover in place will invalidate the safety approvals and pose

a risk of fire and electrical hazards.

Statement 117

Where to Find Safety and Warning Information

For safety and warning information, see the Regulatory Compliance and Safety Information document

at the following URL:

http://www.cisco.com/c/en/us/td/docs/security/asa/hw/regulatory/compliance/asa5500x_rcsi.html

This RCSI document describes the international agency compliance and safety information for the

Cisco ASA 5500-X series. It also includes translations of the safety warnings used in this guide.