Specifications

7-13
Cisco ASA 5580 Getting Started Guide
78-18101-01
Chapter 7 Scenario: Site-to-Site VPN Configuration
Configuring the Other Side of the VPN Connection
This concludes the configuration process for Security Appliance 1.
Configuring the Other Side of the VPN Connection
You have just configured the local adaptive security appliance. Next, you need to
configure the adaptive security appliance at the remote site.
At the remote site, configure the second adaptive security appliance to serve as a
VPN peer. Use the procedure you used to configure the local adaptive security
appliance, starting with
“Configuring the Adaptive Security Appliance at the
Local Site” section on page 7-5 and finishing with “Viewing VPN Attributes and
Completing the Wizard” section on page 7-12.
Note When configuring Security Appliance 2, use the same values for each of the
options that you selected for Security Appliance
1, with the exception of local
hosts and networks. Mismatches are a common cause of VPN configuration
failures.
What to Do Next
If you are deploying the adaptive security appliance only in a site-to-site VPN
environment, then you have completed the initial configuration. In addition, you
may want to consider performing some of the following steps:
To Do This... See...
Refine configuration and configure
optional and advanced features
Cisco Security Appliance Command
Line Configuration Guide
Learn about daily operations Cisco Security Appliance Command
Reference
Cisco Security Appliance Logging
Configuration and System Log
Messages