Specifications

7-11
Cisco ASA 5580 Getting Started Guide
78-18101-01
Chapter 7 Scenario: Site-to-Site VPN Configuration
Implementing the Site-to-Site Scenario
In addition, identify hosts and networks at the remote site to be allowed to use this
IPsec tunnel to access local hosts and networks. Add or remove hosts and
networks dynamically by clicking Add or Delete respectively. In this scenario, for
Security
Appliance 1, the remote network is Network B (10.20.20.0), so traffic
encrypted from this network is permitted through the tunnel.
In Step 5 of the VPN Wizard, perform the following steps:
Step 1 In the Action area, click the Protect radio button or Do Not Protect radio button.
Step 2 Enter the IP address of local networks to be protected or not protected, or click
the ellipsis (...) button to select from a list of hosts and networks.
Step 3 Enter the IP address of remote networks to be protected or not protected, or click
the ellipsis (...) button to select from a list of hosts and networks.
Step 4 Click Next to continue.