Specifications

7-3
Cisco ASA 5580 Getting Started Guide
78-18101-01
Chapter 7 Scenario: Site-to-Site VPN Configuration
Implementing the Site-to-Site Scenario
Information to Have Available
Before you begin the configuration procedure, obtain the following information:
• IP address of the remote adaptive security appliance peer
• IP addresses of local hosts and networks permitted to use the tunnel to
communicate with resources at the remote site
• IP addresses of remote hosts and networks permitted to use the tunnel to
communicate with local resources
Configuring the Site-to-Site VPN
This section describes how to use the ASDM VPN Wizard to configure the
adaptive security appliance for a site-to-site VPN.
This section includes the following topics:
• Starting ASDM, page 7-3
• Configuring the Adaptive Security Appliance at the Local Site, page 7-5
• Providing Information About the Remote VPN Peer, page 7-6
• Configuring the IKE Policy, page 7-8
• Configuring IPsec Encryption and Authentication Parameters, page 7-9
• Specifying Hosts and Networks, page 7-10
• Viewing VPN Attributes and Completing the Wizard, page 7-12
The following sections provide detailed instructions for how to perform each
configuration step.
Starting ASDM
This section describes how to start ASDM using the ASDM Launcher software.
If you have not installed the ASDM Launcher software, see
Installing the ASDM
Launcher, page 4-5.
If you prefer to access ASDM directly with a web browser or using Java, see
Starting ASDM with a Web Browser, page 4-7.