Specifications

Chapter 3 Installing the ASA 5580

Installing the Chassis

3-4

Cisco ASA 5580 Getting Started Guide

78-18101-01

This unit should be mounted at the bottom of the rack if it is the only unit in the

rack.

When mounting this unit in a partially filled rack, load the rack from the bottom

to the top with the heaviest component at the bottom of the rack.

If the rack is provided with stabilizing devices, install the stabilizers before

mounting or servicing the unit in the rack. Statement 1006

This procedure requires two or more people to position the adaptive security

appliance on the slide assemblies before pushing it in to the rack.

To install the adaptive security appliance in the rack, perform the following steps:

Step 1 Attach the chassis side rail to the adaptive security appliance by aligning the

chassis rail to the stud on the adaptive security appliance, pressing the chassis side

rail in to the stud, and then sliding the chassis side rail backwards until you hear

the latch catch, as shown in

Figure 3-2.

Figure 3-2 Chassis Side Rail Attachment

Note The tapered end of the chassis side rail should be at the back of the

adaptive security appliance. The chassis side rail is held in place by the

inner latch.

Step 2 Repeat Step 1 for each chassis side rail.

2345678

Cisco IPS 4270 SERIES

Intrusion Prevention Sensor

201990