Installation guide

8
Cisco AS5850 Universal Gateway Commissioning Guidelines
78-10537-04
How to Commission the Cisco AS5850 Universal Gateway
00:01:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet6/0, changed
state to up
00:01:17: %SYS-6-BOOTTIME: Time taken to reboot after reload = 209 seconds
00:01:17: %OIR-6-REMCARD: Card removed from slot 11, interfaces disabled
00:01:17: %OIR-6-REMCARD: Card removed from slot 12, interfaces disabled
Press RETURN to get started!
Router>
Verify the Operating Environment
To verify the operating environment, perform the following steps as appropriate for your system.
Step 1 Power up the Cisco AS5850.
Step 2 Verify that there are no critical grounding, cooling, or power problems.
AS5850# show environment
Slot # Exhaust Sensor Inlet Sensor
(deg C) (deg C)
0 54.5 37.0
1 50.5 31.5
2 32.0 32.5
4 44.5 35.5
5 44.0 28.5
6 26.5 24.5
7 26.5 24.5
8 41.5 27.5
9 40.5 29.0
10 42.0 29.0
11 33.5 33.0
13 47.0 32.0
Slot # 3.3V 5V MBUS 5V
(mv) (mv) (mv)
0 3260 4968 5080
1 3260 4920 5072
2 3276 4976 5088
4 3268 4976 5080
5 3260 4976 5104
6 3284 5016 5128
7 3288 4984 5120
8 3276 4976 5080
9 3276 4968 5080
10 3256 4976 5088
11 3272 4944 5072
13 3264 4944 5096
Slot # 5.15V MBUS 5V 48V AMP_48 1.60V
(mv) (mv) (Volt) (Amp) (mv)
24 5520 5136 49 13 1640
24 RAW 690 642 698 209 410
25 5536 5136 50 13 1808
25 RAW 692 642 712 218 452
PEMF slot 24: AC Shelf is normal
PEMF slot 24: Blower is normal. (MBUS Port2 returns 8E)