Installation guide

7
Cisco AS5850 Universal Gateway Commissioning Guidelines
78-10537-04
How to Commission the Cisco AS5850 Universal Gateway
R7000 CPU at 259Mhz, Implementation 39, Rev 2.1, 256KB L2, 2048KB L3 Cache
Last reset from Mbus reset
Channelized E1, Version 1.0.
X.25 software, Version 3.0.0.
Bridging software.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
1404 terminal line(s)
24 Channelized T1/PRI port(s)
2 Channelized T3 port(s)
507K bytes of non-volatile configuration memory.
32768K bytes of Compact Flash card at slot 0 (Sector size 128K).
16384K bytes of Flash internal SIMM (Sector size 256K).
Note If a hardware card is not recognized, verify that you are running the optimum version of Cisco IOS
software. See the hardware-software compatibility matrix, available online (logon required) at
http://www.cisco.com/cgi-bin/front.x/Support/HWSWmatrix/hwswmatrix.cgi.
The following system message and prompt appears.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Because the universal gateway has never been configured, the Cisco IOS software cannot find a
startup-config file, so abort the configuration dialog. In this example, the Cisco IOS software is
configured manually; the automatic setup script is not used. The RSC card auto-detects the state of each
card in the chassis.
00:00:09: %MBUS-3-UNKNOWN_REGISTER: Status change message for register 9 in slot 6,
value = 2
00:00:09: %MBUS-3-UNKNOWN_REGISTER: Status change message for register 0 in slot 6,
value = 88
00:00:09: %MBUS-3-UNKNOWN_REGISTER: Status change message for register 9 in slot 6,
value = 0
00:00:37: %SYS-7-NV_BLOCK_INIT: Initalized the geometry of nvram
00:00:42: %LINK-5-CHANGED: Interface FastEthernet6/0, changed state to initializing
00:00:42: %LINK-5-CHANGED: Interface GigabitEthernet6/1, changed state to initializing
00:00:42: %DSCREDCLK-5-BSWITCHT: Backup clock matched to the active clock reference,
slot 3 line 0
00:00:43: %DSCREDCLK-5-BNORMAL: Backup clock moving to NORMAL to phase lock to the
active clock
00:00:43: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet6/0, changed
state to down
00:00:43: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet6/1, changed
state to down
00:00:45: %LINK-5-CHANGED: Interface GigabitEthernet6/1, changed state to administratively
down
00:00:52: %LINK-3-UPDOWN: Interface FastEthernet6/0, changed state to up
00:00:53: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet6/0, changed
state to up
00:00:56: %SYS-5-CONFIG_I: Configured from memory by console
00:01:15: %LINK-3-UPDOWN: Interface GigabitEthernet6/0, changed state to up
00:01:17: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 5850 Software (C5850-P6-M), Version 12.1(20001120:130907)
[ssangiah-121_5_xv_build 100]
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Mon 20-Nov-00 05:09 by