Installation guide

Cisco AS5850 Universal Gateway Commissioning Guidelines

78-10537-04

How to Commission the Cisco AS5850 Universal Gateway

One asynchronous PPP call requires the following:

• 1 DS0 channel

• 1 channel in a TDM bus

• 1 integrated modem

• 1 TTY line

• 1 asynchronous interface

One synchronous PPP call requires the following:

• 1 DS0 channel

• 1 serial interface channel

Note Synchronous PPP calls require HDLC resources. Each T3 trunk card supports 256 HDLC components

and each STM1 card supports 512 HDLC components. E1 trunk cards do not have HDLC resource

limitations.

How to Commission the Cisco AS5850 Universal Gateway

This section contains the following information:

• Task 1. Verifying Basic Setup, page 5

• Task 2. Configuring Basic Cisco IOS Software, page 23

• Task 3. Configuring Channelized T1 or E1, page 28

• Task 4. Configuring Channelized T3, page 29

• Task 5. Configuring ISDN PRI, page 31

• Task 6. Configuring the Serial Interfaces, page 36

• Task 7. Configuring Ports and Lines, page 38

• Task 8. Enabling IP Basic Setup, page 38

• Task 9. Testing Asynchronous EXEC-Shell Connections, page 39

• Task 10. Configuring GigE Egress, page 42

• Task 11. Confirming the Final Running Configuration, page 43

Task 1. Verifying Basic Setup

To verify that basic system components are functioning, see the following sections:

• Analyze the System Boot Dialog, page 6

• Inspect the Feature Cards, page 9

• Use the DSIP Commands, page 12

• Inspect the Initial Running Configuration, page 15

• Explore the Cisco IOS File System, page 17