Installation guide

43
Cisco AS5850 Universal Gateway Commissioning Guidelines
78-10537-04
How to Commission the Cisco AS5850 Universal Gateway
Task 11. Confirming the Final Running Configuration
After you complete the tasks in this section, your final running configuration looks like this.
Gateway# show running-config
Building configuration...
Current configuration:
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Gateway
!
resource-pool disable
!
modem-pool Default
pool-range 0/0-0/215,1/0-1/323,13/0-13/215
!
ip subnet-zero
ip host aurora 172.21.100.100
ip domain-name the.doc
ip name-server 172.22.11.10
ip name-server 172.22.12.11
!
redundancy
mode classic-split
isdn switch-type primary-5ess
!
controller T3 0/0
framing m23
cablelength 0
t1 1-2 controller
!
controller T1 0/0:1
framing esf
pri-group timeslots 1-24
[no] ip route-cache distributed
Enables/disables VIP distributed switching on the
interface. If both ip route-cache flow and ip
route-cache distributed are configured, the VIP
does distributed flow switching. If only ip
route-cache distributed is configured, the VIP
does distributed switching.
[no] ip mroute-cache
Enables/disables fast switching on the interface.
logging event link-status
Logs link-status events to the syslog server or
other management server.
negotiation auto
Auto-negotiates the link speed for the line
(100mbps, 1000mpbs for GigE).
[no] cdp enable
Enables/disables Cisco Discovery Protocol on the
interface. This is on by default.
Table 10 Summary of Optional Gigabit Ethernet Interface Commands (continued)
Command Purpose