Installation guide

31
Cisco AS5850 Universal Gateway Commissioning Guidelines
78-10537-04
How to Commission the Cisco AS5850 Universal Gateway
No alarms detected.
MDL transmission is disabled
FEAC code received:No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Internal
Data in current interval (270 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 32 15 minute intervals):
0 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation, 0 P-bit Err Secs,
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs,
0 Unavailable Secs, 0 Line Errored Secs,
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Task 5. Configuring ISDN PRI
Figure 4 displays the logical controller components inside a Cisco AS5850. The figure demonstrates that
a T3 trunk card requires T1 and T3 controller configuration settings. In the figure, only the fourth
controller is configured. There are a total of 28 T1 controllers to configure.
Figure 4 Matching Controller Settings
36802
Cisco AS5850
T1
controller
28
controller t1 0/0:4
framing esf
pri-group timeslots 1-24
T3
controller
T3 trunk
controller T3 0/0
framing m23
t1 4 controller
PSTN