Installation guide

30
Cisco AS5850 Universal Gateway Commissioning Guidelines
78-10537-04
How to Commission the Cisco AS5850 Universal Gateway
To configure channelized T3, perform the following steps.
Step 1 Use the enable command and password to enter privileged EXEC mode. You are in privileged EXEC
mode when the prompt changes to Gateway#.
Gateway> enable
Password: password
Gateway#
Step 2 Enter global configuration mode. You are in global configuration mode when the prompt changes to
Gateway(config)#.
Gateway# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Gateway(config)#
Step 3 Enter controller configuration mode to configure your T3 controller slot and port. Slot values range from
0 to 5 and 8 to 13. Port number is always 0.
Gateway(config)# controller t3 slot/port
Gateway(config-controller)#
Step 4 Enter your telco’s framing type: c-bit or m23.
Gateway(config-controller)# framing c-bit
Step 5 Enter your clock source: internal or line.
Gateway(config-controller)# clock source line
Step 6 Enter your cablelength: values range from 0 to 450 feet.
Gateway(config-controller)# cablelength 450
Step 7 Configure your T1 controllers. Range is 1 to 28. In this instance, all 28 T1s are configured at once.
Gateway(config-controller)# t1 1-28 controller
or omit specified T1 controllers while configuring others. In this instance, T1 controllers 11-14, 21, 22,
and 24-28 are not configured.
Gateway(config-controller)# t1 1-10,15-20,23 controller
Step 8 Return to privileged EXEC mode.
Gateway(config-controller)# Ctrl-Z
Gateway#
Tip To save the gateway configuration, save it to NVRAM.
Verify
To verify that your controller is up and running and no alarms have been reported:
• Enter the show controller command and specify the controller type, slot, and port numbers:
Gateway# show controller t3 1/0
T3 1/0 is up.
Applique type is Channelized T3