Installation guide

10
Cisco AS5850 Universal Gateway Commissioning Guidelines
78-10537-04
How to Commission the Cisco AS5850 Universal Gateway
Each universal port card contains its own DRAM memory and performs its own call processing. A
normal CPU utilization range is 20-40%.
Step 2 If the feature card does not come up, perform the following troubleshooting steps.
a. Look for LED lights on the feature card. If the lights are off, try reseating the card.
Note More more information about the feature card LEDs, see the Cisco AS5850 Universal
Gateway Card Guide that shipped with this system.
b. Verify that the RSC connection to the other cards is up.
AS5850# show dsi
6/0 is up, line protocol is up
Hardware is AmdFE, address is 00b6.eaf4.2b00 (bia 00b6.eaf4.2b00)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Unknown duplex, Unknown Speed, 100BaseTX/FX
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/600, 0 drops; input queue 0/600, 0 drops
1 minute input rate 0 bits/sec, 0 packets/sec
1 minute output rate 0 bits/sec, 0 packets/sec
45114 packets input, 3795862 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
22342 packets output, 15268108 bytes, 0 underruns(0/0/0)
0 output errors, 0 collisions, 1 interface resets
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Interface 6/0
Hardware is AMD Laguna
ADDR:64FD7E24, FASTSEND:6001ED60, MCI_INDEX:0
DIST ROUTE ENABLED:0
Route Cache Flag:0
LADRF=0x0000 0x0000 0x0000 0x0000
CSR0 =0x00000072, CSR3 =0x00001044, CSR4 =0x0000491D, CSR15 =0x00008180
CSR80 =0x00009900, CSR114=0x00000000, CRDA =0x16462250, CXDA =0x16465230
BCR9 =0x00000001 (full-duplex)
CSR5 =0x00000001, CSR7 =0x00000A20, CSR100=0x0000F000, CSR125=0x00005C3C
BCR2 =0x00001000, BCR9 =0x00000001, BCR18 =0x000019E0, BCR22 =0x0000FF06
BCR25 =0x00000017, BCR26 =0x0000000B, BCR27 =0x00000000, BCR32 =0x00004080
BCR4 =0x000000C0, BCR7 =0x00000090, BCR20 =0x00000303, BCR39 =0x00000000
BCR33 =0x00004800, BCR34 =0x0000FFFF
HW filtering information:
Promiscuous Mode Enabled, PHY Addr Enabled, Broadcast Addr Enabled
PHY Addr=00B6.EAF4.2B00, Multicast Filter=0x0000 0x0000 0x0000 0x0000
amdp2_instance=0x64FD9B70, registers=0x48000000, ib=0x6461D20
rx ring entries=512, tx ring entries=512
rxring=0x6461D80, rxr shadow=0x64FD9D2C, rx_head=77, rx_tail=0
txring=0x6463DC0, txr shadow=0x64FDA558, tx_head=327, tx_tail=327, tx_count=0
spurious_idon=0, throttled=0, enabled=0, disabled=0
rx_framing_err=0, rx_overflow_err=0, rx_buffer_err=0, rx_bpe_err=0
rx_soft_overflow_err=0, rx_no_enp=0, rx_discard=0, rx_miss_count=0