Specifications

requirethatyouconfigurethemwiththeconfigurecommand.For
informationontheconfigurecommand,refertotheCiscoAS5800
UniversalAccessServerSoftwareInstallationandConfigurationGuide
thatshippedwithyoursystem.
ToolsandPartsRequired
Youneedthefollowingtoolsandpartstoinstallorreplaceatrunkcard.
Ifyouneedadditionalequipment,contactaservicerepresentativefor
orderinginformation.
• CT1orCE1trunkcard(DS5812CT1=,DS5812CE1=,
respectively)
• CT1orCE1interfacecables(Seethesections"CT1TrunkCard
CablesandPinouts"and"CE1TrunkCardCablesandPinouts"
foralistofproductnumbers.)
• Cableties
• YourownESDpreventionequipmentorthedisposablegrounding
wriststrapincludedwithallupgradekits,fieldreplaceableunits
(FRUs),andspares.
• CiscoAS5800UniversalAccessServerSoftwareInstallationand
ConfigurationGuide(DOCAS5800SICG)
RemovingaTrunkCard
ToremoveatrunkcardfromtheCisco5814dialshelf,completethe
followingsteps:
Warning
Beforeopeningthechassis,disconnectthetelephonenetworkcablestoavoidcontactwith
telephonenetworkvoltages.
Caution
Trunkcardsweigh8lb(3.6kg)each.Usetwohandswhenremovingorreplacingatrunkcard.
ToremoveatrunkcardfromtheCisco5814dialshelf,followthesesteps:
Step1 Notetheslotinwhichthetrunkcardisinstalled.Ifyoudecidetoinstallthe
newtrunkcardinthesameslot,thiswillhastentheinstallationprocess.
Step2 Initializethesoftwarebusyoutprocedurebyenteringthefollowingcommand
inprivilegedEXECmode:
busyout shelf-number/slot-number
Step3 VerifytheyellowmaintenanceLEDlightsonthetrunkcard,whichindicates
thecardisofflineandreadytoberemoved.
Step4 AttachanESDpreventivewriststrapbetweenyouandanunpaintedchassis
surface.
Caution
TopreventESDdamage,handletrunkcardsbyejectorleversandcarrieredgesonly,anduse
anESDpreventivewriststraporothergroundingdevice.
Step5 DisconnectallCT1orCE1trunklinecablesandsecurethemoutoftheway
usingcableties,ifnecessary.
Step6 UsingaNumber2Phillipsscrewdriver,loosenthepanelfastenersatthetop
andbottomofthetrunkcardfrontpanel.(See.)
Figure13UsingtheEjectorLever