Specifications

1-20
Cisco AS5800 Operations, Administration, Maintenance, and Provisioning Guide
DOC-7810814=
Chapter1 Introduction
Using the Setup Script
Step 8 If you plan to use a system controller network management system through which you can administer
your Cisco AS5800, enter yes to the following prompt, then enter substitute your own IP address and
system controller password when prompted.
Configure System Management? [yes/no]: yes
System Controller IP address: 10.10.1.1
System Controller password: cisco
Step 9 The system controller supports the Simple Network Management Protocol (SNMP); enter yes at the
prompt. The community string is used by the system controller to communicate with its managed
shelves. You need to determine a password for this function; the default password is public.
Configure SNMP Network Management? [yes]:
Community string [public]:
Step 10 Enter the interface information used to connect to the system controller at the prompt.
Enter interface name used to connect to the management network from the above interface
summary: Ethernet0/1/0
Step 11 The system then displays current interface summary information, as shown in Table 1-1, that will help
you configure your available egress interfaces.
Configuring interface Ethernet0/1/0:
Configure IP on this interface? [no]:
Note If you change a shelf-ID number, you must perform a reload before the new shelf-ID is
saved in NVRAM. Use the show version command after you have changed a shelf-ID and
performed a reload.
Table 1-2 Current Interface Summary
Interface IP-Address OK?
1
1. Any interface listed with OK? value “NO” does not have a valid configuration.
Method Status Protocol
FastEthernet0/0/0 unassigned NO unset down down
Ethernet0/1/0
10.10.1.1
2
2. The IP address shown requires configuration by the user; it is not a default
configuration.
YES set up up
Ethernet0/1/1 unassigned NO unset down down
Ethernet0/1/2 unassigned NO unset down down
Ethernet0/1/3 unassigned NO unset down down