Specifications

3-36
Cisco AS5800 Operations, Administration, Maintenance, and Provisioning Guide
DOC-7810814=
Chapter 3 Operations
Configuring PPP and Authentication
Fast Switching and Route Caching Statistics
Inspect fast-switching and route-caching performance statistics for the call. Incoming asynchronous
calls can be fast switched. However, some features disable fast switching.
Step 1 Inspect the queuing characteristics of the asynchronous interface. Notice that the queuing strategy is
first-in-first-out (fifo).
5800-NAS# show interface async 1/2/02
Async1/2/02 is up, line protocol is up
modem=1/2/02, vdev_state(0x00000000)=CSM_OC_STATE, bchan_num=(T1 1/0/0:4:6)
vdev_status(0x00000001): VDEV_STATUS_ACTIVE_CALL.
Hardware is Async Serial
Interface is unnumbered. Using address of FastEthernet0/1/0 (172.22.66.23)
MTU 1500 bytes, BW 9 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set, keepalive not set
DTR is pulsed for 5 seconds on reset
LCP Open
Open: IPCP
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/10, 0 drops; input queue 1/10, 0 drops
5 minute input rate 0 bits/sec, 1 packets/sec
5 minute output rate 0 bits/sec, 1 packets/sec
1683 packets input, 112764 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
1 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
1626 packets output, 108235 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
PPP: LCP Open, CHAP (<- AAA), IPCP
Superficial information about what is open in PPP.
The field “(<- AAA)” is somewhat misleading.
Local authentication is also from AAA.
For more detailed IPCP information, enter the
show caller user detail command.
IP: Local 172.22.66.23, remote 172.22.90.2
The IP addresses on each end of the link. These
values are only displayed on the output for the
asynchronous interface.
Counts:
Counters from the show interface async 1/2/09
command output.
Table 3-7 Show Caller User Command Descriptions (continued)
Field Description