Installation guide

21
• Connect each E1/PRI port to an RJ-45 jack with a straight-through RJ-45-to-RJ-45 cable. (See Figure 25, Figure 26, and
Figure 27.)
Note If you choose a port with 75-ohm input impedance, use an RJ-45-to-75-ohm coaxial cable adapter and plug it into
that port. Use software commands to choose a particular port and the line termination on that port. For
information on software commands, see the
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software
Configuration Guide.
Warning The E1 interface card may only be installed in an ACA-permitted customer equipment or a Data Terminal Equipment
(DTE) that is exempted from ACA’s permit requirements. The customer equipment must only be housed in a cabinet
that has screw-down lids to stop user access to overvoltages on the customer equipment. The customer equipment
has circuitry that may have telecommunications network voltages on them. Statement 90
Figure 25 Connecting a 2-Port or 4-Port Feature Card on the Cisco AS5350XM Universal Gateway to an RJ-45 Jack
35673
E1 cable
RJ-45 jack