Specifications

4-52 Chapter 4: Collaboration
Selected Part Numbers and Ordering Information
For More Information
For more information about the Cisco TelePresence System, visit: http://www.cisco.com/go/telepresence.
Physical dimensions
(H x W x D)
Minimum room dimensions: 8 x 6 x 8 feet
• Table top: Height 3'0.5", Width 3'2", Depth 1'4.5"; Base width 2'7.5", Base depth 1'4.5"
• Freestanding pedestal: Height 5'6.5", Width 3'2"; Base width 2'9", Base depth 2'1"
• Wall mounted pedestal: Height 5'6.5", Width 3'2"; Base width 2'9", Base depth 1'1.5"
• Wall mounted: Height 2'6", Width 3'2"
Weight
230 lb with pedestal; 65 lb without pedestal and CODEC
Power
350W (3 Amps @ 120V to 1.5 Amps @ 240V); Two power plugs are required
Video and Audio Specifications
Bandwidth consumption
3 to 4 Mbps (1080p) or 1 to 3 Mbps (720p) for IP QoS connections is recommended.
Note: The bandwidth recommendations for the Cisco TelePresence System 500 are identical
to those for the Cisco TelePresence System 1000.
Video standards
HM.264
Video frame rate
30 frames per second using H.264
Data and graphics frame
rate
• Graphics sharing at 5 frames per second (standard configuration)
• Optional graphics sharing at 30 frames per second using a dedicated presentation codec
Native National Television
Standards Committee
(NTSC)
720p and 1080p
Resolution
1920 x 1080 Native
Audio standards
G.711 and AAC-LD (22 kHz)
Audio features
Cisco Dynamic Echo Cancellation
Cisco TelePresence high-
definition camera
• Complementary Metal Oxide Semiconductor (CMOS) 2/3-inch sensor
• C-mount lens
• 1080p 30
• Minimum illumination 300 lux
• Manual focus
H.264 interoperability
Using CIF and G.711 with CUVC35xx Series platforms
Additional Specifications
Firmware upgrades
Downloadable from Cisco Unified Communications Manager
Video network features
Intelligent packet loss recovery of video transmission
Network interface
• 1 LAN or Ethernet (RJ-45); 100/1000 Mbps
• Internal 4-port Ethernet switch with 2 PoE (IEEE 802.3af) ports on codec
Power cords
Select the appropriate power cord pair option to plug into the wall outlets in the country where
the Cisco TelePresence system will be deployed.
Auxiliary control unit
CTS-LIGHT-CTRL—This is an optional control unit that is used to turn off system lighting when
not in a meeting and is not required for Cisco TelePresence 500 operation. The built-in lighting
for the system is included and does not need to be ordered separately.
Presentation codec
CTS-HFR-COLLAB—This chargeable option adds a dedicated presentation codec to enable
high-frame-rate Auto Collaboration.
Mounting Options (Choose
one at NC)
• CTS500-STRUC-PED—This mounting option provides a free standing floor mount for the CTS-
500 with codec integrated to the pedestal
• CTS500-STRUC-TABL—This mounting option is for the display sitting on a table or shelf and
codec sits on the floor with a cable harness
• CTS500-STRUC-WALL—This mounting option is for the display attached to a wall and codec
sits on the floor with a cable harness