Specifications

Configuring MMP
Cisco AS5300 Universal Access Server Software Configuration Guide
3-56
Verify
To verify the MMP configuration on each server:
• Enter the show sgbp command:
5300# show sgbp
Group Name: test Ref: 0x4780B252
Seed bid: default, 50, default seed bid setting
Member Name: 5300-3 State: active Id: 9
Ref: 0x4780B54D
Address: 172.22.21.8
5300# show sgbp
Group Name: test Ref: 0x4780B54D
Seed bid: default, 50, default seed bid setting
Member Name: 5300-7 State: active Id: 1
Ref: 0x4780B252
Address: 172.22.21.12
Note the following:
— Check to make sure State is active. State set to idle indicates there is a misconfiguration on
either side.
— Check to make sure the username and password are configured for the sgbp group; otherwise
the servers will not be able to talk to each other.
Tips
If you are having trouble:
• Enter the debug sgbp ? command to view a list of available debugging commands:
5300# debug sgbp ?
errors SGBP errors
events SGBP events
hellos SGBP connection hellos
messages SGBP messages
queries SGBP mastership queries
11 5300(config-if)# ppp multilink
Enable Multilink PPP on the virtual
template interface.
12 5300(config-if)# ppp authentication chap
Enable PPP authentication on the virtual
template interface.
13 5300(config-if)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Return to enable mode.
This message is normal and does not
indicate an error.
1. A virtual template is a serial interface configuration with no hardware association.
2. DHCP = Dynamic Host Configuration Protocol.
Table 3-29 Configuring MMP (Continued)
Step Command Purpose