Specifications

Using the Setup Script
Cisco AS5300 Universal Access Server Software Configuration Guide
1-8
Step 24 Configure your serial intefaces by responding to the following prompts:
Do you want to configure Serial0 interface? [no]: yes
Note If using the serial interfaces to route data from the T1/PRI or E1/PRI ports to a
WAN, you need to configure IP on the interface. Enter the IP address of the WAN device
to which the data will be routed.
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 173.20.30.40
Subnet mask for this interface [255.255.0.0] :
Class B network is 173.20.0.0, 16 subnet bits; mask is /16
Configure LAT on this interface? [no]:
Configure AppleTalk on this interface? [no]:
Configure IPX on this interface? [no]:
Step 25 Repeat Step 24 to configure the other three serial interfaces, if necessary.
Step 26 Configure the PRI D-channel (signaling channel):
Do you want to configure Serial0:23 (PRI D-channel) interface? [no]: yes
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 173.20.30.40
Subnet mask for this interface [255.255.0.0] :
Class B network is 173.20.0.0, 16 subnet bits; mask is /16
Configure LAT on this interface? [no]:
Configure AppleTalk on this interface? [no]:
Configure IPX on this interface? [no]:
Step 27 Repeat Step 26 for each D-channel.
After you complete the configuration script, messages similar to the following appear.
The following configuration command script was created:
hostname 5300
enable secret 5 $1$WVLB$YD0zbQsu3nqZh/bnN2fwX0
enable password guessme
line vty 0 4
password guessagain
syscon shelf-id 0
syscon address 172.87.98.1 sctest
snmp-server community public
!
appletalk routing
no decnet routing
no ip routing
no clns routing
ipx routing
no vines routing
no xns routing
no apollo routing
!
line 1 120
speed 115200
flowcontrol hardware
login local
autoselect during-login
autoselect ppp