Specifications

First-Time Configuration 1-7
Getting Started
Step 18 Enter the letter corresponding to the signaling type to support modem pooling over the
T1 lines or press Enter to accept the default:
The following line signaling types are available:
[a] e&m-fgb
[b] e&m-fgd
[c] e&m-immediate-start
[d] fxs-ground-start
[e] fxs-loop-start
[f] sas-ground-start
[g] sas-loop-start
Enter the line signaling type [a]:
Step 19 Enter the tone signaling type:
The following tone signaling types are available: dtmf | mf
Enter the tone signal type [dtmf]:
Step 20 Press Enter to configure digital number identification service (DNIS) over T1 lines:
Do you want to provision DNIS address information? [yes]:
Step 21 Repeat Step 15 to Step 20 to configure the remaining controllers.
Step 22 Enter yes to configure the Ethernet 0 interface (this is the Ethernet 10BaseT port) if you
plan to use this interface to manage and monitor the access server:
Configuring interface parameters:
Do you want to configure Ethernet0 interface? [no]: yes
Configure IP on this interface? [no]: yes
IP address for this interface: 172.21.40.10
Subnet mask for this interface [255.0.0.0] :
Class B network is 172.21.0.0, 16 subnet bits; mask is /16
Configure LAT on this interface? [no]:
Configure AppleTalk on this interface? [no]:
Configure IPX on this interface? [no]:
Step 23 Press Enter or enter yes to configure the Fast Ethernet 0 interface (this is the Ethernet
100BaseT port) to connect the access server to a LAN:
Do you want to configure FastEthernet0 interface? [yes]: yes
Note Full duplex mode enables simultaneous data transfer between a sending and a
receiving station.
Operate in full-duplex mode? [no]: yes
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Configure LAT on this interface? [no]:
Configure AppleTalk on this interface? [no]:
Configure IPX on this interface? [no]: