Specifications

Using the Setup Script
Cisco AS5300 Universal Access Server Software Configuration Guide
1-6
What is the username of the test user? [user]:
What is the password of the test user? [passwd]:
Will you be using the modems for outbound dialing? [no]:
Configure for Async IPX? [yes]: no
Configure for Appletalk Remote Access (ARA)? [no]: yes
AppleTalk Network for ARAP clients [1]:
Zone name for ARAP clients [ARA Dialins]:
Allow ARAP "Guest" logins? [yes/no]: yes
Step 12 Enter the letter corresponding to the ISDN switch type that matches your telco switch
type or press Enter to accept the default:
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Step 13 Press Enter to allow users to dial in via ISDN or analog modems:
Next, you will be prompted to configure controllers.
These controllers enable users to dial in via ISDN or analog modems.
Do you intend to allow users to dial in? [yes]:
There are 8 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller T1 0,1,..etc in software corresponds to Port 0,1,..etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Step 14 Enter the number of controllers you will be using for the PRI configuration or press Enter
to configure all controllers:
Enter # of controllers, you will be using for PRI configuration [8]:
Configuring controller parameters:
Step 15 Set the CAS configuration options for the first controller you are configuring. First, press
Enter to set robbed-bit signaling on the controller:
Configuring controller T1 2:
Will you be using CT1 (robbed bit signaling) on this controller? [yes]:
Step 16 Enter your telco framing type:
The following framing types are available: esf | sf
Enter the framing type [esf]:
Step 17 Enter your telco line code type:
The following linecode types are available: ami | b8zs
Enter the line code type [b8zs]: