Specifications

Configuration Tasks

Cisco IOS Release 12.0(3)T

11 cas-group channel timeslots range type signal Conﬁgures all channels for E&M, FXS,

and SAS analog signalling. Enter 1-24

for T1. If E1, enter 1-31.

Signalling types include e&m-fgb,

e&m-fgd, e&m-immediate-start,

fxs-ground-start, fxs-loop-start,

sas-ground-start, and sas-loop-start.

You must use the same type of signalling

that your central ofﬁce uses.

For E1 using the Anadigicom converter,

use cas e&m-fgb signalling.

12 controller t1 number Enters controller conﬁguration mode to

conﬁgure the third controller port (there

are a total of four controller ports). The

controller ports are labeled 0 through 3

on the Quad T1/PRI and E1/PRI cards.

13 framing {sf | esf} Enters the framing type designated by

your telephone company.

14 clock source line internal Conﬁgures the internal PRI clock source.

Note that only one PRI can be clock

source primary and one PRI can be clock

source secondary. All other controller

ports use an internal PRI clock source.

15 linecode {ami | b8zs | hdb3} Enters the line code type designated by

your telephone company.

16 cas-group channel timeslots range type signal Conﬁgures all channels for E&M, FXS,

and SAS analog signalling. Type 1-24

for T1. If E1, type 1-31.