Specifications

ManualsBrandsCisco ManualsComputer equipmentAironet 700 Series

351

352

353

354

355

356

357

358

359

360

22-7

Cisco IOS Software Configuration Guide for Cisco Aironet Access Points

OL-5260-01

Chapter 22 Troubleshooting

Resetting to the Default Configuration

Step 8 After the access point reboots, you must reconfigure the access point by using the Web-browser interface

or the CLI. The default username and password are Cisco, which is case-sensitive.

Using the CLI

Follow the steps below to delete the current configuration and return all access point settings to the

factory defaults using the CLI.

Step 1 Open the CLI using a Telnet session or a connection to the access point console port.

Step 2 Reboot the access point by removing power and reapplying power.

Step 3 Let the access point boot until the command prompt appears and the access point begins to inflate the

image. When you see these lines on the CLI, press Esc:

Loading "flash:/c350-k9w7-mx.v122_13_ja.20031010/c350-k9w7-mx.v122_13_ja.20031010"

...###########################################################################

################################################################################

####################

Step 4 At the ap: prompt, enter the flash_init command to initialize the Flash.

ap: flash_init

Initializing Flash...

flashfs[0]: 142 files, 6 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 7612416

flashfs[0]: Bytes used: 3407360

flashfs[0]: Bytes available: 4205056

flashfs[0]: flashfs fsck took 0 seconds.

...done initializing Flash.

Step 5 Use the dir flash: command to display the contents of Flash and find the config.txt configuration file.

ap: dir flash:

Directory of flash:/

3 .rwx 223 <date> env_vars

4 .rwx 2190 <date> config.txt

5 .rwx 27 <date> private.config

150 drwx 320 <date> c350.k9w7.mx.122.13.JA

4207616 bytes available (3404800 bytes used)

Step 6 Use the rename command to change the name of the config.txt file to config.old.

ap: rename flash:config.txt flash:config.old

Step 7 Use the reset command to reboot the access point.

ap: reset

Are you sure you want to reset the system (y/n)?y

System resetting..Xmodem file system is available.