Specifications

19-11
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-5260-01
Chapter 19 Configuring Repeater and Standby Access Points
Configuring a Hot Standby Access Point
Use this command to check the standby configuration:
show iapp standby-parms
This command displays the MAC address of the standby access point, the standby timeout, and the
poll-frequency values. If no standby access point is configured, this message appears:
no iapp standby mac-address
If a standby access point takes over for the monitored access point, you can use the show iapp statistics
command to help determine the reason that the standby access point took over.
Standby State: Init The standby access point is initializing link tests with the
monitored access point.
Standby State: Running The standby access point is operating in standby mode and is
running link tests to the monitored access point.
Standby State: Stopped Standby mode has been stopped by a configuration command.
Standby State: Not Running The access point is not in standby mode.
Table 19-2 Standby Status Messages (continued)
Message Description