Specifications

11-15
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-5260-01
Chapter 11 Configuring WDS, Fast Secure Roaming, and Radio Management
Configuring WDS and Fast Secure Roaming
Enabling Layer 3 Mobility on an SSID
Use the Network ID entry field on the SSID Manager page to map an SSID to a specific mobility network
ID. Figure 11-9 shows the SSID Manager page.
Figure 11-9 Network ID Entry Field on the SSID Manager Page
CLI Configuration Example
This example shows the CLI commands that are equivalent to the steps listed in the “Enabling Layer 3
Mobility on an SSID” section on page 11-15:
AP# configure terminal
AP(config)# interface dot11radio 0
AP(config-if)# ssid L3Mobility
AP(config-if-ssid)# mobility network-id 11
AP(config-if-ssid)# end
In this example, the SSID L3Mobility is mapped to mobility network ID 11.
For complete descriptions of the commands used in this example, consult the Cisco IOS Command
Reference for Cisco Aironet Access Points and Bridges.
Configuring the Authentication Server to Support Fast Secure Roaming
The WDS device and all access points participating in CCKM must authenticate to your authentication
server. On your server, you must configure usernames and passwords for the access points and a
username and password for the WDS device.
If your server runs Cisco ACS, follow these steps to configure the access points on your server:
Step 1 Log into Cisco Secure ACS and click Network Configuration to browse to the Network Configuration
page. You must use the Network Configuration page to create an entry for the WDS device. Figure 11-10
shows the Network Configuration page.