Specifications

11-6
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-5260-01
Chapter 11 Configuring WDS, Fast Secure Roaming, and Radio Management
Configuring WDS and Fast Secure Roaming
Figure 11-3 Required Components for Layer 3 Mobility
Configuring WDS on the WLSM
For instructions on configuring WDS on a switch’s Wireless LAN Services Module (WLSM), refer to
the Catalyst 6500 Series Wireless LAN Services Module Installation and Configuration Note.
Click this link to browse to the information pages for the Cisco Structured Wireless-Aware Network
(SWAN):
http://www.cisco.com/en/US/netsol/ns340/ns394/ns348/ns337/networking_solutions_package.html
Configuring WDS and Fast Secure Roaming
This section describes how to configure WDS on your network and fast, secure roaming on your wireless
LAN. This section contains these sections:
• Guidelines for WDS, page 11-7
• Requirements for WDS and Fast Secure Roaming, page 11-7
• Configuration Overview, page 11-7
• Configuring Access Points as Potential WDS Access Points, page 11-8
• Configuring Access Points to use the WDS Device, page 11-13
• Configuring the Authentication Server to Support Fast Secure Roaming, page 11-15
• Viewing WDS Information, page 11-21
• Using Debug Messages, page 11-22
CiscoWorks Wireless LAN Solution Engine
(WLSE)
CiscoSecure ACS
AAA Server
Catalyst 6500
Wireless Domain Services (WDS) on the
Wireless LAN Solutions Module (WLSM)
Catalyst 6500
Wireless Domain Services (WDS) on the
Wireless LAN Solutions Module (WLSM)
Infrastructure access points
(registered with WDS)
Cisco or Cisco compatible clients (version 2)
117993