Specifications

10-20
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-5260-01
Chapter 10 Configuring Authentication Types
Matching Access Point and Client Device Authentication Types
EAP-SIM authentication
If using ACU to
configure card
Enable Host Based EAP and Use
Dynamic WEP Keys in ACU and
select Enable network access
control using IEEE 802.1X and
SIM Authentication as the EAP
Type in Windows 2000 (with
Service Pack 3) or Windows XP
Set up and enable WEP with full
encryption and enable EAP and
Open authentication for the SSID
If using Windows XP
to configure card
Select Enable network access
control using IEEE 802.1X and
SIM Authentication as the EAP
Type
Set up and enable WEP with full
encryption and enable Require
EAP and Open Authentication for
the SSID
1. Some non-Cisco Aironet client adapters do not perform 802.1x authentication to the access point unless you configure
Open authentication with EAP. To allow both Cisco Aironet clients using LEAP and non-Cisco Aironet clients using LEAP
to associate using the same SSID, you might need to configure the SSID for both Network EAP authentication and
Open authentication with EAP.
Table 10-3 Client and Access Point Security Settings (continued)
Security Feature Client Setting Access Point Setting