User guide
Table Of Contents
- Cisco Aironet 600 Series OfficeExtend Access Point User Guide
- Unpacking the Cisco Aironet 600 Series OfficeExtend Access Point
- Cisco Aironet 600 Series OfficeExtend Access Point Placement
- Cisco Aironet 600 Series OfficeExtend Access Point Overview
- Installation Guidelines
- Understanding Cisco Aironet 600 Series OfficeExtend Access Point LEDs
- Accessing the Cisco Aironet 600 Series OfficeExtend Access Point GUI
- Configuring the Wireless LAN Controller IP Address on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring Radio Channels on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring Personal Wireless LANs
- Viewing the Event Log
- Accessing Online Help
- Troubleshooting
- Cisco Aironet 600 Series OfficeExtend Access Point Local Customer Interface
- Declarations of Conformity and Regulatory Information
- Open Source Used In Cisco Aironet 600 Series OfficeExtend Access Point
1-11
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Chapter 1 Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Configuring Radio Channels on a Cisco Aironet 600 Series OfficeExtend Access Point
Step 3 From the Radio Interface pulldown box, select the desired radio interface, either 2.4 GHz or 5 GHz.
Step 4 From the Status pulldown box, select Enabled to enable the wireless interface.
Step 5 From the Channel Selection pulldown box, select the channel on which this interface will operate.
Note 802.11n mode should be enabled by default. If it is disabled, select Enabled from the
802.11 n-mode pulldown box.
Step 6 Click Apply to commit your changes.