User guide
Table Of Contents
- Cisco Aironet 600 Series OfficeExtend Access Point User Guide
- Unpacking the Cisco Aironet 600 Series OfficeExtend Access Point
- Cisco Aironet 600 Series OfficeExtend Access Point Placement
- Cisco Aironet 600 Series OfficeExtend Access Point Overview
- Installation Guidelines
- Understanding Cisco Aironet 600 Series OfficeExtend Access Point LEDs
- Accessing the Cisco Aironet 600 Series OfficeExtend Access Point GUI
- Configuring the Wireless LAN Controller IP Address on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring Radio Channels on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring Personal Wireless LANs
- Viewing the Event Log
- Accessing Online Help
- Troubleshooting
- Cisco Aironet 600 Series OfficeExtend Access Point Local Customer Interface
- Declarations of Conformity and Regulatory Information
- Open Source Used In Cisco Aironet 600 Series OfficeExtend Access Point
1-10
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Chapter 1 Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Configuring Radio Channels on a Cisco Aironet 600 Series OfficeExtend Access Point
Step 8 The screen will switch to a verification screen. Click Continue when it appears.
The 600 Series OfficeExtend Access point will connect to the controller and download the current
software image. Allow the device 5 minutes to download and reboot with the new code and
configuration.
Configuring Radio Channels on a Cisco Aironet 600 Series
OfficeExtend Access Point
Follow these steps to configure a radio channel for your 600 Series OfficeExtend access point:
Step 1 Access the 600 Series OfficeExtend access point GUI as described in “Accessing the Cisco Aironet 600
Series OfficeExtend Access Point GUI” section on page 1-5.
Step 2 From the Home Summary page, click Configuration to open the Configure System page.