User guide
Table Of Contents
- Cisco Aironet 600 Series OfficeExtend Access Point User Guide
- Unpacking the Cisco Aironet 600 Series OfficeExtend Access Point
- Cisco Aironet 600 Series OfficeExtend Access Point Placement
- Cisco Aironet 600 Series OfficeExtend Access Point Overview
- Installation Guidelines
- Understanding Cisco Aironet 600 Series OfficeExtend Access Point LEDs
- Accessing the Cisco Aironet 600 Series OfficeExtend Access Point GUI
- Configuring the Wireless LAN Controller IP Address on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring Radio Channels on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring Personal Wireless LANs
- Viewing the Event Log
- Accessing Online Help
- Troubleshooting
- Cisco Aironet 600 Series OfficeExtend Access Point Local Customer Interface
- Declarations of Conformity and Regulatory Information
- Open Source Used In Cisco Aironet 600 Series OfficeExtend Access Point
1-6
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Chapter 1 Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Accessing the Cisco Aironet 600 Series OfficeExtend Access Point GUI
Step 2 With the 600 Series OfficeExtend access point connected to your home router/gateway as described in
the procedure
“Installation Guidelines” section on page 1-4, enter the IP address of the 600 Series
OfficeExtend access point in the Address field of your Internet browser (http://<ap-ipaddress>) and
click Go.
Note The default IP address is 10.0.0.1.
Note Make sure your laptop is not connected to your company’s network using a virtual private
network (VPN) connection.
The 600 Series Office Extend Access Point Login page appears.
Step 3 When prompted, enter the username and password to log into the access point.
Note The default username and password are admin and admin.