System information
Disconnect power from the AP.
Disconnect the power jack for external power or the Ethernet cable for inline power.
1.
Press and hold the MODE button while you reconnect power to the AP.2.
Hold the MODE button until the Status LED turns amber, and then release the button.
The Status LED turns amber in approximately 1 to 2 seconds.
3.
After the AP reboots, reconfigure the AP and use the web browser interface, the Telnet interface, or
Cisco IOS Software commands.
Note: The AP is configured with the factory default values that include:
The IP address, which is set to receive an IP address with DHCP♦
The default username and password, "Cisco"♦
4.
Reset the APAP 350 That Runs Cisco IOS Software
Complete the steps in this section in order to reset an AP 350 that runs Cisco IOS Software.
Note: Cisco IOS Software−based APs have a default configuration that includes a username and password
combination. Both the username and password are "Cisco", which is case−sensitive. After you reset to factory
defaults, be prepared to give "Cisco" as both the username and password when you are prompted by either the
GUI or the CLI.
If the privileged command prompt ap# is available in the CLI, the write erase command and the reload
command erase the startup configuration and reset the unit.
If the GUI is available, choose System Software > System Configuration. Press the Reset to Defaults
button.
If neither the GUI nor the CLI is available with sufficient privileges, complete these instructions in order to
use the Mode button:
Disconnect power from the AP.
Disconnect the power jack for external power or the Ethernet cable for inline power.
1.
When the AP 350 begins to boot, press ESC.
Xmodem file system is available.
flashfs[0]: filesystem check interrupted!
The system has been interrupted, or encountered an error
during initialization of the flash filesystem. The following
commands will initialize the flash filesystem, and finish
loading the operating system software:
flash_init
ether_init
tftp_init
boot
ap:
2.
At the ap: prompt, issue the flash_init command .3.
Cisco − Password Recovery Procedure for the Cisco Aironet Equipment