System information
Select the letter for the firmware file that displays. This message appears while the AP starts the
firmware:
Inflating firmware file name
When the Express Setup screen appears, begin to reconfigure the AP with the terminal emulator or an
Internet browser.
10.
Reset the APVxWorks Version 11.07 or Later
Complete these steps in order to reset the AP on versions 11.07 and later:
Connect to the AP.1.
When the Summary Status screen appears, reboot the AP.
In order to reboot, you can unplug and then replug the power connector or press CTRL−X.
Here is an example of the Summary Status screen:
2.
When the AP reboots and the Summary Status screen reappears, issue the :resetall command.
Note: If you do not allow users to browse in a read−only manner without the need to log in, you do
not see the Summary Status screen. Instead, you are prompted for a username and password. Enter
any username and password. You then see this prompt:
Authentication Failed − Retry? (y/n)
Note: Answer n to the question. You are now able to issue the :resetall command. In order to allow
or not allow users to browse in a read−only manner, use the User Manager Setup:
3.
Cisco − Password Recovery Procedure for the Cisco Aironet Equipment