System information

When the Express Setup screen appears, begin to reconfigure the AP with the terminal emulator or an
Internet browser.
10.
Reset for Boot Block Version 1.02 or Later
Complete these steps in order to reset your AP if the boot block version on your AP is version 1.02 or later:
Connect to the AP.1.
Click OK.2.
Press Enter.3.
When the Summary Status screen appears, reboot the AP.
In order to reboot, you can unplug and then replug the power connector or press CTRL−X.
Here is an example of the Summary Status screen:
4.
When the memory files are listed under the heading Memory:File, press CTRL−W within five
seconds in order to reach the boot block menu.
5.
Complete these steps in order to copy the AP installation key to the AP DRAM:
Press C in order to choose Copy file.a.
Press 1 in order to choose DRAM.b.
Press the selection letter for AP Installation Key.c.
Note: If the list of configuration files contains the file VAR Installation Key, you must copy that file
to DRAM along with the installation key. In order to copy the VAR installation key to DRAM, press
C in order to choose Copy file, press 1 in order to choose DRAM, and press the selection letter for the
VAR Installation Key.
6.
Complete these steps in order to reformat the AP configuration memory:
Press CTRL−Z and press ! in order to choose FORMAT memory bank from the available
options.
a.
Press 2 in order to choose Config.b.
Press Y in order to confirm the FORMAT command.c.
7.
Complete these steps in order to copy the installation key back to the configuration memory:
Press C in order to choose Copy file.a.
Press 2 in order to choose Config.b.
Press the selection letter for AP Installation Key.c.
8.
In order to run the AP firmware, press R in order to choose Run.9.
Cisco − Password Recovery Procedure for the Cisco Aironet Equipment