System information

Aironet 340 Series Bridge
For Software Version 8.65 or Later
If you forget the password that allows you to configure the 340 bridge through the console port, you must
completely reset the configuration. Complete these steps in order to delete the current configuration and return
all settings to the factory defaults:
Use a straight−through cable with 9−pin male to 9−pin female connectors in order to connect the
COM 1 or COM 2 port on your computer to the RS−232 port on the bridge.
For more information, see the Cabling Guide for Console and AUX Ports.
1.
Open a terminal−emulation program on your computer.
Note: These instructions describe HyperTeminal. Other programs are similar.
2.
Enter a name in the Connection Description window.3.
Select an icon for the connection.4.
Click OK.5.
In the Connect To window, use the Connect using pull−down menu in order to select the port where
the cable is connected.
6.
Click OK.7.
In the Port Settings window, make these selections:
Bits per second (baud): 9600♦
Data bits: 8♦
Parity: None♦
Stop bits: 1♦
Flow Control: None♦
8.
Click OK.9.
In the Connection Description window, enter a name and select an icon for the connection.10.
Click OK.11.
Press Enter.12.
Cisco − Password Recovery Procedure for the Cisco Aironet Equipment