System information

For Software Version 11.xx or Later
If you forget the password that allows you to configure the 350 bridge through the console port, you must
completely reset the configuration. Complete these steps in order to delete the current configuration and return
all settings to the factory defaults:
Use a straight−through cable with 9−pin male to 9−pin female connectors in order to connect the
COM 1 or COM 2 port on your computer to the RS−232 port on the bridge.
For more information, see the Cabling Guide for Console and AUX Ports.
1.
Open a terminal−emulation program on your computer.
Note: These instructions describe HyperTeminal. Other programs are similar.
2.
Enter a name in the Connection Description window.3.
Select an icon for the connection.4.
Click OK.5.
In the Connect To window, use the Connect using pull−down menu in order to select the port where
the cable is connected.
6.
Click OK.7.
In the Port Settings window, make these selections:
Bits per second (baud): 9600♦
Data bits: 8♦
Parity: None♦
Stop bits: 1♦
Flow Control: None♦
8.
Click OK.9.
Press Enter.10.
When the Main Menu screen appears, reboot the bridge.
Turn the unit off and then back on.
11.
When the bridge reboots and the Summary Status screen reappears, issue the :resetall command.
Note: The :resetall command is valid for only 2 minutes, immediately after the bridge reboots. If you
do not issue and confirm the :resetall command within the 2 minutes, reboot the bridge again.
12.
Press Enter.13.
Enter Yes.14.
Press Enter in order to confirm the command.15.
After the bridge reboots and the Express Setup screen appears, reconfigure the bridge with the
terminal emulator or an Internet browser.
16.
Cisco − Password Recovery Procedure for the Cisco Aironet Equipment