System information

Click the Commands menu.1.
Choose Edit Properties.2.
Under the System Parameters tab, enter the correct value or values for the SSIDs.
Check with your network administrator in order to get the correct SSIDs.
3.
Click OK in order to save your configuration changes.4.
Set Defaults
In order to set the client adapter to its defaults, click the System Parameters tab. On the bottom right corner
of the panel, click Defaults.
CEM Password
You need a password in order to run CEM, which permits the addition or modification of WEP keys. If you
lose or forget this password, try the default password "Cisco". On earlier versions of CEM, try the default
password "Aironet". If the default passwords do not work, you must reinstall the CEM utility.
Windows Systems
For instructions to install the utilities on a Microsoft Windows system, refer to these documents:
Installing Windows 95 Drivers and Utilities for the Cisco Aironet 340/350 Series Client Adapters•
Installing Windows 2000 Drivers and Utilities for the Cisco Aironet 340/350 Series Client Adapters•
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration
Guide for Windows, OL−1394−06
•
Cisco − Password Recovery Procedure for the Cisco Aironet Equipment