Specifications

4-11
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 4 Configuring VLANs
A Wireless VLAN Deployment Example
Creating and Configuring VLANs on the Access Point
For this example, you will create 5 VLANs using the information in Table 3-2.
Note To avoid error messages in the event log, do not enable the VLANs until you have finished creating them
and associated SSIDs to them.
Creating the Native VLAN
You must create and identify a native VLAN before the access point can connect to the trunk and
communicate with the switch. Follow these steps to create the native VLAN.
Step 1 Use your web browser to browse to the access point’s summary status page.
Step 2 Click Setup. The Setup page appears.
Step 3 In the Associations section, click VLAN. The VLAN Setup page appears (Figure 4-6).
Figure 4-6 VLAN Setup Page
Step 4
Enter 1 in the Default VLAN ID field.
Step 5 Enter Native VLAN in the VLAN Name field.
Step 6 Click Add New. The VLAN ID #1 Setup Page appears (Figure 4-7).