Specifications

Chapter 2 Using the Management Interfaces
Using SNMP
2-24
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Navigating the CLI
The organization of the CLI pages is identical to the web-browser pages. Follow
these steps to browse to the CLI pages with Telnet:
Step 1 On your computer’s Start menu, select Programs > Accessories > Telnet.
If Telnet is not listed in your Accessories menu, select Start > Run, type Tel net
in the entry field, and press Enter.
Step 2 When the Telnet window appears, click Connect and select Remote System.
Note In Windows 2000, the Telnet window does not contain pull-down
menus. To start the Telnet session in Windows 2000, type open
followed by the access point’s IP address.
Step 3 In the Host Name field, type the access point’s IP address and click Connect.
Using SNMP
You use an SNMP management application to configure the access point with
SNMP. Follow these steps to configure the access point with SNMP:
Step 1 Compile the MIB you need to use in your SNMP management application. MIBs
supported by the access point are listed in Supported MIBs.
Step 2 Use a web browser, a Telnet session, or the console interface to open the Express
Setup page in the access point management system.
Step 3 Enter an SNMP community name in the SNMP Admin. Community field and
click OK or Apply.
Step 4 Follow this link path to reach the SNMP Setup page:
a. On the Summary Status page, click Setup.
b. On the Setup page, click SNMP in the Services section of the page.