Specifications

13-45
Cisco Aironet Access Point Software Configuration Guide
OL-0657-07
Chapter 13 Diagnostics and Troubleshooting
Resetting to the Default Configuration
Steps for Firmware Versions 11.06 or Earlier
Follow the steps in this section if your access point is running firmware version
11.06 or earlier.
Note The following steps reset all configuration settings to factory defaults,
including passwords, WEP keys, the IP address, and the SSID. If you do not
need to reset the entire configuration, use the Configuration Reset buttons on
the System Configuration Setup page in the web-browser interface. Consult
the “Resetting the Configuration” section on page 9-16 for more information
on the reset buttons in the web-browser interface.
Determining the Boot-Block Version
The steps you follow to reconfigure the access point depend on the version of the
access point’s boot block. Follow these steps to find out which boot block version
is on your access point:
Step 1 Open a Telnet session to the access point.
Note You can also use these instructions while communicating with the
access point through the console port or with an SNMP manager. Skip
to Step 3 if you use an SNMP manager.
Step 2 Type :cmd and press Enter to switch from text-browser mode to SNMP mode.
Step 3 Type bootblockVersion and press Enter. Text appears with information about the
system. If your access point’s boot block version is 1.01, the text might look like
this:
OID: iso.org.dod.internet.private.enterprises.aironet.awcVx.awcSystem.
bootblockVersion
Value [RO]: 1.01
Step 4 Type exit and press Enter to return to text-browser mode.